Epoxy Air Extractor 500 ml.
- Easy removal of air bubbles on the surface
- Better flow of the surface
- No more heat source needed so no expanding air from your substrate.
- Handy spray packaging
The Epoxy Air Extruder ensures that annoying air bubbles disappear on the surface of your epoxy projects and that the surface flows better.
When casting epoxy, the substrate must often first be impregnated. Normally, the surface was treated with a heat source as. The problem with this is that when heating is too long, the air from the substrate starts to expand and only more air enters the epoxy. This to the frustration of many epoxy enthusiasts!
With the Epoxy Air Vent, this problem is a thing of the past. After the epoxy has been cast and flowed out, the air bubbles formed are simply removed by simply applying the Airblast with the handy nebulizer. Air bubbles disappear like snow in the sun and the epoxy also works out better.
Pay attention! Only apply a mist coat on the Epoxy Breather. The spray layer must disappear within a few seconds.
Apply the epoxy impregnation layer to the substrate and let it rest for a few minutes.
Set the sprayer to the desired atomization and spray crosswise with quick strokes over the epoxy surface. The bubbles will disappear immediately. Repeat as often as necessary.
Highly flammable liquid and vapor. Do not use a heat source in combination with this product.
Keep away from heat / sparks / open flames / hot surfaces.
Work in a well-ventilated area.
Eye contact: rinse the eye with running water for 15 minutes. Consult a doctor.
Skin contact: Repeated exposure may cause skin dryness or cracking.