Hardener / Catalyst T
Condensation silicone (RTV-2) hardener. 1 to 3% addition.
- Low viscosity
- Can be used in all condensation hardening RTV-2 systems
- Curing time and pot life adjustable
- Add 1 to 3%
You can use this hardener for curing condensation silicone (RTV-2). The pot life and curing time can be adjusted by adding more or less hardener, with a minimum of 1% to a maximum of 3%. As an example, you need 10 to 30 grams of hardener (B component) on 1 kilogram of silicone (A-component). Usually 2% is added.
Store this product between 5°C and 25°C in the closed original packaging. The "best before" (THT) is indicated on the packaging.
Wear personal protective equipment, etc. (see section 8). Avoid contact with eyes and skin. Do not breathe gases / vapors / aerosols. Provide adequate ventilation. Close opened packaging again properly.
Extremely flammable. Take measures to prevent static charge. Keep away from open flames, heat sources and sparks.
Irritating to eyes and skin.
Eye contact: rinse the eye with running water for 15 minutes. Consult a doctor.
Skin contact: Remove mechanically using a cloth or piece of paper. Take off dirty or soaked clothing. Wash off immediately with plenty of soap and water. In case of large quantities, take an emergency shower immediately. Consult a doctor.
After ingestion: Drink plenty of water in small portions - but only if the person is conscious. Do not induce vomiting. Consult a doctor.