Tin and Zamak
Most silicones are suited for casting temperatures up to 180 o C. However, some silicones may be exposed to higher degrees for short periods of time up to 400 ° C. Thus, you can use silicone molds for tin or zamak alloys. Of course, this depends on the size of the casting. The warmer the alloy the smaller the cast should be. It is also advisable to make the form as thin as possible and to put it on a thermally conductive substrate. So the heat is conducted away quickly ..
You can choose between HTV silicone plates or liquid two-component silicone, which cures at room temperature as condensation silicone (C HT 60) or addition silicone (M 4601).
Because the silicone is degassing at this high temperature, you probably need to pour two or three times before you get the desired result. We also recommend you use talcum powder on the silicone mold. This powder improves the flowability of the alloy on the surface of the silicone mold.
- Silicone condensation HT 60 (Hard) €33,95 Silicone condensation HT 60 are highly filled and may be used to make molds for the casting of high temperature compounds such as tin and lead.
- Silicone Addition Wacker M4601 €46,25 Silicone Addition Wacker M4601 has a good resistance to casting resins (in particular, polyurethane) and low shrinkage. These silicones are very suitable for making strong, flexible and non greasy molds.
- HTV silicone Drives Blue €424,00 HTV silicone Drives Blue are well suited for the direct pendulum casting pewter figures.
- Ordered before 15:00 (Fridays 13.00), shipped the same day
- Always the best price guarantee...
- Not good? Money back guarantee
- Independent customer reviews on trusted shops
- Free shipping in the Netherlands on all orders of € 50 or more
- Customer Service Tel. 0031 46 410 62 60 or in our shop