Release Agent Spray 0.82 g / cm³ 500 ml.
This wax based release spray is ideal for the treatment of surfaces which are (slightly) porous or whereby the possibility exists that silicones might adhere (mechanically or chemically). The spray can also be applied to the silicone mold itself to facilitate silicone molds made from multiple silicone parts or to release castings from the silicone mold. This spray gives a slightly harder result as the release agent spray 0.75g / cm³.
- Easy spraying action
- Good release
- Not visible
- This spray does not contain silicone.
The best results are obtained by covering the entire surface with a fine layer. Give the product a few minutes to dry before casting the silicon onto it.
Make sure that you covered the entire surface without missing segments. The silicone will possibly adhere to segments without release agent.
The silicone release spray comes in a spraying can of 500 ml.
At least 3 years.
Please note: we cannot ship this product by air freight.
H222 Extremely flammable aerosol.
H229 Pressurized container: May burst if heated.
H336 May cause drowsiness or dizziness.
H411 Toxic to aquatic life with long lasting effects.
P-Code Precautionary Statements
P210 Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking.
P211 Do not spray on an open flame or other ignition source.
P251 Do not pierce or burn, even after use.
P273 Avoid release to the environment.
P410+P412 Protect from sunlight. Do not expose to temperatures exceeding 50 °C/122 °F.
P501 Dispose of contents/container to in accordance with official regulations.
EUH-Code additional hazard information
EUH066: Repeated exposure may cause skin dryness or cracking.